The harvester has a short working time in a year and has a long parking time. Especially in the summer and autumn and rainy season, the humidity in the air is high. If not properly stored and maintained, the harvester will directly shorten the service life of the harvester. How to maintain the harvester has the following experience: 1 special library parking The harvester is a large-scale agricultural machinery, which has made great contributions to the hard work of the master. It should be given a home in order to avoid the wind and rain, the sun and the sun. There are a number of drivers who have to take a simple shed for a variety of reasons, such as being afraid of trouble and being afraid of spending money. This practice is very bad, once the wind blows over the shed, the body is exposed to rain and rust, stainless, can not afford to paint it strange. Therefore, the pilot must build a special hangar based on the type and size of his harvester. 2. Registration All the tools, gauges, fixtures used in random, especially special tools and all kinds of spare parts, must be registered, so that they know what is missing and what they lack. In addition, special parts must be dedicated and custody of personnel should be avoided. Dismantled batteries can be stored separately using intermittent charge water injection or dry storage methods. 3. Cleaning and storage After harvesting season, the inside and outside of the harvester are covered with dirt, dust, vegetation, grains and other debris. Therefore, the harvester must perform a thorough and thorough cleaning before entering the warehouse by flushing it with a water gun. Without a water gun, a long plastic pipe is used to turn on the tap and squeeze the thumb and index finger. This has a great impact. It is easy to wash away the internal and external impurities. 4 timely repair paint After the harvester is cleaned, it is necessary to paint the lacquer in a timely manner where it is found that the fuselage is stripped. As the saying goes, the small hole does not make up, and the big hole bears hardships. Do not underestimate the small paint that falls on one side, and rusting will corrode a large area. 5. Classified maintenance For the lubrication part of the oil seal, after the various belts are removed, wiped and dried, there is room for ventilation, and to prevent insects or rat bites. For all drive chains, wash with diesel oil or kerosene, dry them, put them in oil for 15-20 minutes, or soak overnight in oil to remove them. When no oil drips, apply lubricant to kraft paper. , Put it in a dry and ventilated place. The rubber and plastic products on the harvester are susceptible to aging and deterioration due to exposure to ultraviolet rays from the sun, and have poor flexibility and breakage. Therefore, the storage of rubber parts is best coated with hot paraffin oil on the surface of the rubber and placed in a cool, ventilated and dry place indoors. Springs, belts, rods, tires, etc., may be plastically deformed due to prolonged stress or improper placement. For this purpose, support is needed, such as supporting the tire without pressure load, the pressure spring is always relaxed, the drive belt is removed and stored separately, and the long tool bar is removed to lay flat or vertical. Disposable Tracheostomy Tube Kit Tracheostomy Tube Kit,tracheostomy tube,pediatric tracheostomy tube 4.5,shiley tracheostomy tube Anesthesia Medical Co., Ltd. , https://www.sinoanesthesia.com