Medical Coveralls,Surgical Coverall,Disposable Surgical Clothes,Medical Protective Clothing Ningbo Autrends Prevention Products Co., Ltd , https://www.autrendsafety.com
1. Please confirm the connection of the power supply before the equipment is running.
2. Confirmation of automatic water supply system.
3. Exhaust hole inspection.
4. Confirmation of the gas supply system.
5. When preparing the salt solution, please use analytical grade NaCl and distilled water or deionized water to prepare, and use it immediately.
6. Confirmation of the isolation of the sink seal.
7. After each test, the power supply, air source and water source should be cut off to avoid the equipment being in the standby state for a long time.
8. When cleaning the cabinet, please note:
(1) Protection of the sheath of the temperature sensor.
(2) Protection of glass filters and glass nozzles (cannot use needles or any hard objects to pass through filters or nozzles).
9. In each test or at the end of the test, the solution of the standard measuring cup should be poured out and cleaned in time to avoid the accumulation of crystals in the salt solution and affect the calculation of the settlement.
10. At the end of each test, it is recommended to clean the equipment test cabinet (including spray chamber, salt solution chamber, preheating water tank and sealed water tank) with clean water to keep the equipment clean.
Use of salt spray corrosion tester:
(2) The environmental requirements of the salt spray test machine:
1. The fluctuation of the power supply voltage of the equipment is ≤±10%.
2. The equipment is not directly exposed to direct sunlight or other heat sources. 3. There is no high concentration of dust and corrosive substances around the equipment.
4. There must be more than 600mm space around the equipment.
5. There is no strong airflow in the equipment turnover. When the surrounding air needs to be forced to flow, the airflow should not be directly blown onto the tank.
6. The temperature around the equipment should be kept between 15 °C and 30 °C.
Maintenance method and correct use of salt spray test machine
Maintenance method and correct use of salt spray test machine (1), salt spray test machine use note: